Kitchen Remodeling
| The kitchen is the one room where members of a family can be found eating, working on homework, talking on the phone or just hanging out with friends. The kitchen has always been the nerve center of the household, and never has the kitchen’s central role been more important than it is today. As the centerpiece of the home, there are some interesting alternatives for kitchen that go well beyond the norm. Our kitchen section contains a variety of home improvement options available to homeowners as well as advice on how to keep the busiest place in the house clean.
An Introduction to Dismantling Most Common Mistakes: Before You Start Make arrangements for the removal of any refuse that may accumulate during the remodeling. if you must rent a dumpster, do so in plenty of time or have a pick up truck on hand for hauling the rubbish to the dump. if you plan to salvage the old cabinetry for a workshop or donation to a charitable cause, have a place ready for them to go as you take them out of your work area. Before removing any major appliances, turn off all utilities. This can be done at the individual shut off valves for gas and water. If there are no shut off valves, you will have to turn off the main valve*. The main gas valve is usually located near the gas meter. Remember that, once you turn off the gas to the whole house, ALL pilot lights will have to be relit before they will work again. Without careful planning you may find yourself without hot water when you’re ready to clean up after a hard day’s work. Disconnect uses or turn off circuits to the area in which you will be working. In older homes, the wiring may have been modified over the years and it may not be clear which circuits or fuses control specific areas. If you are unsure, turn off the main power or get professional assistance. Never take a chance with electricity! In addition, tape over the breakers so the won’t be turned on inadvertently. If you plan on upgrading your electrical system and adding new outlets and fixtures, it will be necessary to dismantle all existing outlets and fixtures. Remove all light bulbs. Then, dismantle each fixture by using a screwdriver to unscrew the plate and the receptacle and pull the receptacle out of the box. Put wire nuts on any exposed wires for the interim. The bare copper wire is the ground and does not need to be capped. |